Application:
Removes laitance or trowel marks appeared on new overlaid concrete surface.
Floor Grinder K-60E
Preparation Method:
Remove laitance and trowel marks that causes failure adhesion of coatings. 
Floor Grinder K-60E
Apply cutter with:
Super Dia(Standard)
Applicable machine:
Floor Grinder: K-60 Series
Performances:
200~300m²/hour; 4~6 hrs/set
*** The working performance or the cutter consumption may be carry out differently according to the conditions of flooring materials, floor hardness, adhesiveness and etc at the job sites. ***
Construction Cases of Grinders / Scarifiers
Others Construction Cases
Removal of raindrop marks after concrete overlaid
Roughening reinforced concrete surface
Removal of deteriorated concrete surface
Removal of grease on floor surface
Removal of epoxy thin layer
Removal of epoxy thick layer
Removal of urethane thin layer
Removal of urethane thick layer
Removal of acrylic layer
Removal of MMA (Methyl methacrylate) resin layer
Removal of epoxy coating of pool surface
Removal of adhesives (white glue)
onstruction Videos
LINAX Video: Removal of laitance (K-60E)
LINAX Video: Removal of urethane thick layer (K-60E)
LINAX Video: Roughening reinforced concrete (K-60)
LINAX Video: Roughening reinforced concrete (K-30ENV)
LINAX Video: Removal of grease on floor surface (F-22)
LINAX Video: The performance of K-20 Porche [Edge capability up to 0mm on side wall]
LINAX Video: K-20 Porche Introduction by CG
LINAX Video: FC-20E Introduction by CG
LINAX Video: VS-3E II Introduction by CG
